...

• Required rework to test with 12V - needed to modify resistor dividers
• Connectors are great and really useful when testing a board
• 0 ohm resistors are great for disconnecting things and changing resistor values
• Resistor dividers need to be biased towards IN- (increase R13)
  • Need to tune values - greatly influences time precharge takes
• Need to add a decoupling/bulk cap between HV relay 12V and GND to reduce ripple - 10uF seems to work fine
  
  

Rev 2 Testing

To ensure proper functionality and that nothing in the car is negatively affected by the board, these tests should be completed prior to the final revision

• Noise in the 12V line when the relay is on
• Voltage droops when the relay switches
• Test for noise in the isolated DCDC
• Pre-Charge sometimes doesn't happen when the circuit is turned off then turned on again before the capacitor is fully discharged, this should be further looked into