...
- Pin 1 on all SMT footprints will have rectangular pads with rounded rectangular pads on all other pins.
- Pin 1 on all through-hole footprints will have square pads, all other pins will have circular pads.
- Pin 1 of all footprints will be clearly defined on silkscreen
- All wire-to-board connectors must have clearly visible pinouts on silkscreen
- All components will have a 3D model. The more accurate the better, but at a minimum must provide the maximum bounds on the part.
Connector Standards
- Wire-to-board signals will use 2.0mm Duraclik connectors (DuraClik Connector System).
- Wire-to-board power will use another connector capable of 10A.
- Panelmount connectors will use a sealed, locking connector.
- HV power will use Anderson SB120s.
...