...
- All boards must include title block with board name, Rev X.Y (see below), designer(s), and date the board was sent to fab
- All boards must have 4 mounting holes of [size TBD]
Part Creation
Schematic Symbol
...
- All carrier boards will power controller boards through mezzanine
Mechanical Standards
- All mounting holes
Hardware Revisions
- Hardware revisions will be denoted by Rev X.Y
- X refers to the major revisions, so every time a new version of the board is fabricated, the revision is now Rev X.0
- Y refers to minor revisions prior to fabrication, so each time things are changed after a review
- All boards must be reviewed by the electrical leads prior to fabrication
- All revisions should be properly documented on Confluence under the appropriate project page
...