...

I am sure there are lots on this page, please fix them if you see any!

Harnessing

Connectors

Type

Connectors shall be the Molex 3mm Microfit series whenever possible.

Pinout

Pinouts on schematics will shall be one-one. If net x connects from board 1 to board 2, pin 1 for the connector on board 1 should correspond to pin 1 for the connector on board 2.

Altium

Component

...

Source

All components used shall be from the team’s A365 library. No components shall be from the Altium content vault, a local library, or any other source.

Creation

Templates

All components shall use their respective templates when being created. Templates may specify required parameters, these must be filled in.

...

“CAP ALUM POLY 47UF 20% 35V SMD”

Schematics

Component Source

All components used shall be from the team’s A365 library. No components shall be from the Altium content vault, a local library, or any other source.

Template

All schematic sheets shall use Midnight Sun templates. The title block shall be populated using the relevant sheet parameters.

Component Sourcing

New components shall not be sourced if a suitable alternative already exists in our library.

...