...
During the test, the capacitor discharge circuit started smoking
Once working, DCDC output max is 10.6-10.7V
17-06-2023
R7: 549.5; R8: 4.715k; R9: 1k
So looks like R8 is off as it should be 10k
TR to HV GR it's only 3.511kohms (should be a little over 15kR)
6-2023
Replaced R8 to 10k ohms resistor, but seems like the resistor removed was 10k
Connected back to the power supply and load no change in output voltage
...
VBAT and 3V3 rails in working condition, 5V outputs 0.2V
13-07-2023
tested a few times, working fine however the voltage lines incorrect
split moment I saw, drawing too much current at an extremely low voltage and smoke
gound and power are shorted
next steps: find the shorted component (the one that is smoking), use a thermal camera
Controller Boards
Link to FW Progress + States of CB: Table of Boards