...
The first step to creating a simulation is to set up the geometry.
Preparing Geometry
...
The geometry of the simulation fed into SimScale differs from the illustrative geometry shown above the model. The geometry has been halved, and the tail end of the flow region has been lengthened to allow for total resolution of fluid flow. This allows any air jets, vortices, convection zones, etc to combine, mix and homogenize.
The source of the geometry is a Solidworks assembly called [name] using design tables to generate configurations. Currently, all configurations have been generated, and to use one, one must only select the correct configuration, rebuild the geometry, and save the file.
...