| Table of Contents |
|---|
...
Focused on lowering stresses for Top 30 wall case
Added a total of 12 longitudinal reinforcement tubes to try to add more resistance to bending during impact
all 1” square tubing
Testing the effects of a greater wall thickness (0.113”)
Note: there are currently interferences with floor panels, changes can be made to the reinforcement placement later
...
Stress Results
(not done yet, running into errors - some tubes were split into tiny segments?)
Max Combined Stress (MPa) | ||
Scenario | REV 2.0/3.0? ("July 1_TommyRev.wbpj") | REV5.0 |
B-Pillar | 351.49 | to do |
Side 60 | 648.65 | to do |
Top 30 | 1374.9 | to do |
Rev 5.1 - Longitudinal Tubes
...
Red = 200 MPa or more
B-Pillar
...
Comments
Failing only at joints
Ideas for reinforcements
Add gussets at each of these joints
Sheet metal might be overkill if we are trying to fix these stresses
Tubes might not be the best way to reduce stresses at joints
Side 60
...
Comments
A lot of stresses on the top catamaran
A lot of stress at the front passengers floor
Ideas for reinforcements
Sheet metal over these tubes
More tubes at these areas. Basically a sheet metal wall, but made up of tubes
Top 30
...
Comments
A lot of stresses on these longitudinal tubes
Ideas for reinforcements
More tubes in the longitudinal direction (front to back)