DRI: Aidan Lehal Salman Rasheed
...
The tubes (grey circular) will be welded together using a jig, and the ribs (Orange) will be welded with the same jig.
...
Welding Jig
...
Welding jig supporting horizontal pipe while aligning rib at designated location.
...
Welding Jig supporting two tubes to create a T joint or corner once welded
MDF Mold:
Made out of MDF, slots for ribs to be placed, with hardstops at the front and back to prevent movement.
MDF does not require welding
MDF base can be reused by removing the ribs from the slots and replacing them with new ones (that fit a different panel)
MDF will have to be purchased
...
Sturdy and one shape use, very durable
Requires welding (will need to see what aluminum tubes can withstand) or adhesive
MDF Base (
...
Second Design)
After review of the potential options, an MDF base was cadded. The ability to replace ribs for a different mold was an advantage we wanted to utilize. We also did not require any welding or glue of any sort. We would use cutouts in the MDF to position the planks and wood screws to solidify their position.
...
8 Rib Planks (cut to length with slots)
2 Side Planks
2 Hard-stop Planks
20 Aluminum Brackets (https://www.homedepot.com/p/Everbilt-2-1-2-in-Zinc-Plated-Double-Wide-Corner-Brace-8-Pack-12434/315016358 )
>150 3/4” Wood Screws
Impact Drill/Drill/Screwdriver
90degree Clamp/Blocks
Shims the same height as the clamp/blocks
Aluminum Extrusions Base (Current Design: 2021-06-14)
Based on MDF’s properties, the team was unsure if tolerances between the rib slots and alignment features would be to tight or too loose. Additionally, without a clearly defined way to secure the ribs in place while ensuring all ribs remained parallel to each other, MDF seemed like it would be less precise than required for this application. Moving back to aluminum but opting for an aluminum extrusion base would be ideal because the channels in the tubes would act as linear slides for the ribs to be aligned correctly, reducing the amount of in house machining we have to do.
...