...

• probably want to limit myself to just the pages on confluence

  • resources on confluence page has been curated and tailored towards solar car and MS14 design

    • want to limit scope and understand our specific design the most

Research

• It seems like I ended up just taking note of some confluence pages and other resources that relate to battery box design

  • No notes or summaries were made on this confluence page because of lack of time.

Step 1 - Battery Box Basics, Curriculum, and Onboarding

History and Overview of Battery Module Design

Battery Module Rev 5 - Mechanical - Confluence (atlassian.net)

• This page directs to Rev 5, but the side bar shows that there is Rev 7 (Final)

Step 2 - Notes on Existing Design Logs and Documentation of Battery Box Design

“Some other links for MSXII's battery pack build discussion and compression plates:
Battery Pack Design Proposal
2017-03-01 Battery Pack Design Review”

• These links were recommended by Micah during S2021. He sent them into the battery box channel on slack

  • The source message of this was:
    ”Check out this confluence page for a bit more detail on the selection of the Nickel Strips: Nickel Strip Selection

    You can also read through these pages to get a bit more history on our battery modules:
    Battery Module Rev 5

    This page has some details for a prototype battery module with compression plates instead of spot welding for MSXII (we ended up doing a spot welded design):
    Battery Modules

    Some other links for MSXII's battery pack build discussion and compression plates:
    Battery Pack Design Proposal
    2017-03-01 Battery Pack Design Review

    @Renzo You might want to check out some of the notes from Prof. Fowler on this last page as well:
    Notes from Prof. Fowler “

• There are more access to other reports related to the Battery Box in the resources section below

Resources

...