TL;DR
...
Use the Elecrow.OutJob file included in your project or copy one in another folder and press
‘Generate content ->’ text for all three containers and you’re doneat the end if you’re lazy.
Overview and Access
After the gerbers are generated for a project, the last step is to use the release manager tool to create the documentation, fabrication files, the bill of material and the step files.
...
PDF
This output includes ALL of the documentation of your board which includes
Schematic Files
Bill of Material
2D PCB Image
3D PCB Image
Electrical Rules Check
Design Rules Check
For the options for set up, follow the image below
For the data source, the default option is fine, but if it does not output correctly, usually it is the first option
An example will be on the bottom
Note: The PDF will pop up after it is fully generated
Fabrication Files
These are ALL the gerbers that you generated which include
Gerber Files
The number of gerbers you generated earlier should be the same as what is outputted
NC Drill Files
For the options for set up, follow the image below
BOM & STEP
These are your
Bill of Materials in excel form
STEP file
For the options for set up, follow the image below
An example will be on the bottom
When everything is set-up, press the ‘Generate content ->’ text in the blue highlighted box.
For all the ‘Path in server’ and ‘Local Path’, it will be preset, but if it isn’t configured properly, route it to your project file in your drive. Usually, all the files will be found in the ‘Project Outputs for [Project Name]’ file in the project file.
TL;DR
Use the Elecrow.OutJob file included in your project or copy one in another folder and press
‘Generate content ->’ text for all three containers and you’re done.
...
Press what the red circle is showing.
Hard Copy
Unless your lead tells you anything about the hard copy, please do not touch it. 
...