...

1. Using the 2 part epoxy (DP-420) (making sure to pull the neoprene over the edges of the seat back) adhere to seat back and seat pan

2. Adhere the polyethylene closed cell to the neoprene with the tape/spray (the foam will need to be pressed down with a weight and left for 1-3 hours to dry). The tape/spray should be applied to both sides of the cushioning.

3. Place the open cell on the areas that need to be padded based on the mockup (again use the tape/cement spray to secure the soft open cell to the closed cell)

4. The contouring of the foam will need a jig

How to construct the jig:

Seat Pan:

Materials:

·        Carbon fiber flat panel from the flat panel (2 layer carbon fiber each side)

...