...
- Make a schematic symbol and footprint for a SMD test point and add them to the regulator outputs
- Add appropriate (values?) decoupling caps for MCU and CAN ICs (Echoing Kevin's concern: filtering?)
- Expand pinout descriptions for MCU (what to include?)
- Add extra caps on input and output of the regulators to be populated if needed after load testing
- Add new dual-use mezzanine connector footprint to schematic library
- Add debug LEDs (attach to MCU and mezzanine)
PCB design decisions
- All components on top of board except clik-mate connectors and debug LEDs
- Board dimension target is 5 cm x 5 cm (not of vital importance)
- Mounting holes (M4) on each corner
- Mezzanine connector will be close to the center of the board
- 2-Layer PCB with 1oz copper
...