Page Comparison

...

•  Check thermistor readings and re-work the temperature checking logic if necessary (from old power select project)
•  Write up new requirements for power select
•  Completely revamp old project to take into consideration new requirements
•  Get the project mockup ready by commenting out unnecessary things (depends on what bits of hardware aren’t being used)

Front power distro

•  Sort out smoke_bts7200 after refactor (check Selina’s onsite notes from Oct. 25)
•  Ensure we set the config to only enable / check the relevant channels (hardware dependent) (channel 3 and 7 from smoke_bts7200)
•  MCI will be powered off front power for this mockup but not for actual car. Figure out if anything needs to be changed to allow for this, and if so make the changes
•  Get the project mockup ready by commenting out unnecessary things

...