Versions Compared

Version Old Version 13 New Version 14
Changes made by

Renzo Villanoy

Renzo Villanoy

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Once all the fibreglass parts have been made, label each part with masking tape.

  2. Check to see if sizing is correct and that edges, corners and faces line up as intended.

  3. BB & RE Side Walls (Refer to master CAD)

    1. Mark locations of all ribs, cam covers and wall brackets with masking tape.

...

  1. BB & RE Bottoms (Refer to master CAD)

    1. Mark locations of all internal components (battery modules, heat set mounts, support walls, rear elec, fans)Rib Placement

  •  Lid Latches

  1. Set three of the latches to open CCW and the other three to open CW.

  2. Secure the latches to the lid with rubber washers on both sides.

    1. Latches on the left side of the lid will open CCW.

    2. Latches on the right will open CW.

...