Page Comparison

...

1. Rod end assembly:
   Put #4 onto the threads of #2 with the flat side facing away from the bearing. Twist the nut till approx 14mm from the end of the thread, do not tighten. Repeat this for the other tie rod.
   

   Image RemovedImage Added

   Image RemovedImage Added

2. Tube assembly:
   Weld (welding is usually outsourced to someone who can weld, ask DRI about weldingoutsource the weld to E3 or if someone on the team knows how to weld) #3 to #1 on both sides with inserting the smaller diameter side of #3 into the tube.

   1. The highlighted faces are to be welded.

      

   2. The #1 is transparent to show the welded assembly.

      

3. Put the rod end assembly from step 1 and the tube assembly from step 2 together by inserting the rod end into threads of #3.

   

4. Adjust the rod end, nut, and tube until there is one thread to the left of the nut, then tighten the nut onto the tube side (highlighted).

   Image RemovedImage Added

5. Repeat steps 3 and 4 for the other rod end assembly from step 1.

...