...
**nets that have been simulated (not routed on pcb) are light gray
checking failed or not analyzed nets
if nets are highlighted bright red
select a net, right-click, and select show errors
view all information for a net - right-click and select details
performing analysis on individual nets
nets must be selected on the right hand list of the signal integrity panel
1. double click on the net in the left hand list to select it and move to the right
2. in the selected state, you can perform further configurations before running a simulation
set the direction of bidirectional pins in a net
select the affected net in the right hand list
change the in/out status for each selected bidirectional pin by right-clicking and selecting a status