Page Comparison

Sanding

• will need different seams

• after sanding, spray filler and spray paint can make the parts to look not like 3D printed

• able adjust how smooth we want the surface to be

• can be accurate in a way since we are sanding the parts that we want

• could make a mistake of sanding to much

• if it is a large part, time consuming to sand the whole part

https://www.youtube.com/watch?time_continue=258&v=NLoB52nPuao&feature=emb_logo

https://www.youtube.com/watch?v=0vgynnYzo08

Using Acetone

• acetone does its job to smooth our the surface

• takes only about an hour

• must be printed with ABS (Acrylonitrile Butadiene Styrene)

  • which gives toxic chemical when heated

  • shrinks when it is cold

    • not suitable

• when doing this, could be dangerous since it is flammable

• details can be gone

https://www.youtube.com/watch?v=6xFUNFG-UKE

https://www.youtube.com/watch?v=rn4edNztaPU

Using Spray paint / Spray Fast drying polyurethane

• spray paint (more than usual) then spray a layer fast drying polyurethane, fan it

• do this multiple times

• no need to sand

• the details might be gone