...
- All components are labeled in a logical manner
- Maybe get someone else to look at it and make sure that they can follow the placement if any names had to be placed in weird orientations, etc.
- Connectors are labeled
- With function on top side (power input, CAN, Thermistor, etc.)
- With pinout on bottom side (or top side if possible)
- MSXIV Logo is on the board
- Correct board Rev is listed
- Pin 1 labeled on all ICs
- Ensure bottom silkscreen is mirrored
- Optional parts (such as CAN termination) is labeled
- Ensure all polarized components are labelled
- Double-check all of silkscreen in 3D mode
BOM
- Ensure that all parts are in the BOM, and have Supplier part numbers - ideally manufacturer part numbers as well
- Ensure the no components are ordered on tape and reel
- This just increases cost for no reason (since we don't have a pick and place machine)
- Digikey part numbers that end in DKR usually have tape and reel - watch out for them!
...