...
The connections to the cells seem to be crimped improperly, parts of them were squished during crimping, allowing the pins to push out the end of the connector. We should ask Molex for the proper crimp tool, as this happens a lot. This may also be contributing to the fact that the 14 and 16 pin connectors are tough to remove, require 1 hand on the board and 1 hand on the
...
I dropped the board. It landed on the screw hole. Maybe we should consider moving the screws away from the edge of the board a little more? But the main point here is that I should have been more careful with the board. It landed on a thin rubber mat on the floor in my work area.
...
Power Validation
All power nets are not connected. Good.
...