Page Comparison

...

1. Heat gun for rework

2. Agilent Power Supply

   1. banana - alligator clips

   2. ultra-fit power connection

3. Weller Soldering Iron

   1. Solder, flux, copper braid, solder tips, brass sponge, solder paste, kapton tape, extra solder tip

4. Tweezers and Exactoknife

5. Controller Boards, parts, and stencil, we should have parts for 30

   1. The rev from JLC PCB with the pick and place panel, and the solder paste scraper blade

6. MPPTs x2 (18-33V)

7. SWD adapters + programmers (Grab box of firmware stuff)

8. Raspberry Pi 3B+, Micro SD Cards, etc.

9. DC-DC Rev 1 box from on top of the electrical shelf (make sure it has the old board, an extra heatsink, push pins and module)

10. PEAK CAN-USB adapter

11. Small spool of 22 gauge wire (preferably two colours)