Page Comparison

...

1. Heat gun for rework

2. Agilent Power Supply

   1. The red and black alligator clips, or at least banana:alligator clips

3. Solder, flux as well, copper braid, solder tips, solder braid cleaner, solder paste, kaptone tape

4. Tweezers and Exactoknife

5. Controller Boards, parts, and stencils, we should have parts for 30.

   1. The rev from JLC PCB with the pick and place panel

6. MPPTs x2 (18-33V)

7. SWD adapters + programmers (Grab box of firmware stuff)

8. Raspberry Pi 3B+, Micro SD Cards, etc.

9. DCDC push pins, heat sink (might have to take off of old DCDC) and vicor module

   1. Take entire DCDC board (Rev 1)