Page Comparison

...

1. Controller Boards, parts, and stencils, we should have parts or 30.

   1. The rev from JLC PCB with the pick and place panel

2. The rest of the board boxes above the electrical bench (have all assembled boards)

   1. LEDs from lights box

   2. Definitely get: center console, pedal and lights assembled boards + their boxes

3. Resistor/capacitor/IC boxes could save us money from having to buy them

4. Raspberry Pi 3B+, Micro SD Cards, etc.

5. Wire spools: 22AWG, 18AWG

6. Molex boxes (microfit + ultrafit + 2pin duraclicks) of connectors + crimps

7. SWD adapters + programmers (Grab box of firmware stuff)

8. Boxes with components from previous boards (e.g. box with lights board stuff)

9. MPPTs x2 (18-33V)

10. Chen’s aux charger board + stencil

11. Power supply to ultrafit for board power (might be attached to agilent supply)

12. Horn

Essentials:

This list exists if Liam/Josh cannot carry all of the above:

1. Keysight 34410A 6.5 digit benchtop DMM

2. Heat gun for rework

3. Agilent Power Supply

   1. The red and black alligator clips, or at least banana:alligator clips

4. Solder, flux as well, copper braid, solder tips, solder braid cleaner, solder paste, kaptone tape

5. Tweezers and Exactoknife

6. Controller Boards, parts, and stencils, we should have parts or for 30.

   1. The rev from JLC PCB with the pick and place panel

7. MPPTs x2 (18-33V)

8. SWD adapters + programmers (Grab box of firmware stuff)

9. Raspberry Pi 3B+, Micro SD Cards, etc.

...