...
Chassis Ground
Control Pilot
N
L
Proximity Detection
From this, 3 of the wires are to be connected to the Elcon charger and 2 will be connected to the Charger Interface board. More information about the Elcon Charger can be found here MS14 Charger (Elcon UHF IP67 sealed and potted 3.3KW)
Charger Interface Board
The control pilot and proximity detection lines are to be crimped to an Ultrafit connector and attached to the charger interface board
...
Elcon Charger Input
It is connected using an AC connector. 2.5 square mm wire.
...
This 4-pin connection will be attached to the Charger Interface board. More information about the board layout and schematic can be found here:
...
| View file | ||
|---|---|---|
|
...